Command Line Reference Guide

Defaults Enabled on all lines.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ping
Test connectivity between the system and another device by sending echo requests and waiting for
replies.
Z9500
Syntax
ping [host | ip-address | ipv6-address] [count {number |
continuous}] [datagram-size] [timeout] [source (ip src-ipv4-
address) | interface] [tos] [df-bit (y|n)] [validate-reply(y|
n)] [outgoing-interface] [pattern pattern] [sweep-min-size]
[sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4-
address) | interface]
Parameters
host (OPTIONAL) Enter the host name of the devices to which
you are testing connectivity.
ip-address (OPTIONAL) Enter the IPv4 address of the device to which
you are testing connectivity. The address must be in the
dotted decimal format.
ipv6-address (OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format,
to which you are testing connectivity.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Control and Monitoring
117