Command Line Reference Guide

Version Description
7.5.1.0 Introduced on C-Series
ip telnet server enable
Enable the Telnet server on the switch.
Z9500
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Z9500
Syntax
ip telnet source-interface interface
Control and Monitoring
111