Command Line Reference Guide

Version Description
6.2.1.1 Introduced on the E-Series.
Usage
Information
When this command is configured, the VLAN is operationally UP if any of the
interfaces specified in the track ip command are operationally UP, and the VLAN
is operationally DOWN if none of the tracking interfaces are operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state
depends on all the members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the
track ip command configuration.
Related
Commands
interface vlan — configures a VLAN.
tagged — specifies which interfaces in a VLAN are tagged.
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Z9500
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Layer 2
1025