Reference Guide

Reloading the chassis will affect existing network traffic.
Continue to install license [yes/no] ? yes
Retrieving license....... (ok)
Validating license....... (ok)
Installing license....... (ok)
License installation successful. Restart chassis to activate license.
4. Reboot the switch to enable the licensed port configuration.
reload
EXEC Privilege mode
Enter Yes at the prompts to save the port configuration and complete the reload; for example:
??? Dell# reload
System configuration has been modified. Save [yes/no] ? yes
Proceed with reload [ yes/no ] ? yes
Displaying License Information
To check the status of the currently installed Z9500 license and display the number of enabled ports, use
the show license command.
• Display the license for the current Z9500 port configuration.
show license
EXEC Privilege mode
Display of the Default 36 40G-Port Installation
If no license is installed, only information about the default 36 40G-port configuration is displayed.
??? Dell# show license
LICENSE INFORMATION
Feature(s) : 36 Ports 84 Ports 132 Ports
[enabled] [disabled] [disabled]
State : no license installed
Display of an Installed 132 40G-Port License
If a 132 40G-port license is installed, the following information is displayed.
??? Dell# show license
LICENSE INFORMATION
Vendor : Dell
Service Tag : XDF-5YU
Product : Dell Networking Z9500
Feature(s) : 36 Ports 84 Ports 132 Ports
[enabled] [enabled] [enabled]
State : license active
Display of an 84 40G-Port License on a Remote Server
To display information about a Z9500 license stored on a remote server using TFTP:
??? Dell# show license tftp://122.3.12.34:/dell_license/z9500_J_Smith.xml
LICENSE INFORMATION
Vendor : Dell
Service Tag : XDF-5YU
Product : Dell Networking Z9500
Feature(s) : 84 Ports
Pay As You Grow
577