Reference Guide

Usage

Information

The password is listed in the configuration file; you can view the password by

entering the show running-config ftp command.

Use the ip ftp password command when you use the ftp: parameter in the

copy command.

Commands

ip ftp username — sets the user name for the FTP sessions.

ip ftp source-interface

Specify an interface’s IP address as the source IP address for FTP connections.

Z9500

Syntax

ip ftp source-interface interface

To delete an interface, use the no ip ftp source-interface interface

command.

Parameters

interface Enter the following keywords and slot/port or number

information:

• For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

• For a Port Channel interface, enter the keyword port-

channel

then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(1.0) Introduced on the Z9500.

Control and Monitoring