Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 nd dad attempts — Configure system to set the flow label field in the packets
to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
Z9500
Syntax
show ipv6 interface interface [linecard slot-id] [brief]
[configured][loopback interface-number] [managementethernet
slot/port] [port-channel number][tengigabitethernet slot |
slot/port] [fortyGigE slot | slot/port] [tunnel tunnel-id]
[vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For the Null interface, enter the keyword null then zero
(0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID.
• For a VLAN interface, enter the keyword VLAN.
• For a port channel interface, enter the keywords port-
channel.
linecard slot-id Enter the linecard slot-id parameters to specify the
Z9500 ports on a line card. The range of slot IDs is from 0 to
2.
832
IPv6 Basics