Reference Guide

cp (OPTIONAL) Enter the cp to clear TCP statistics only from
the Control Processor.
rp (OPTIONAL) Enter the keyword rp1 to clear TCP statistics
only from the Route Processor.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
show tcp statistics — displays TCP traffic statistics.
debug arp
View information on ARP transactions.
Z9500
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
746
IPv4 Routing