Reference Guide

Parameters
system Enter the keyword system to upgrade the operating system
(OS) image.
ftp: file-url Enter the keyword ftp: and specify the location of the
image file in the format
//userid:password@host-ip/
filepath or press Enter to launch a prompt sequence.
scp: file-url Enter the keyword scp: and specify the location of the
image file in the format userid:password@host-ip/
filepath or press Enter to launch a prompt sequence.
tftp: file-url Enter the keyword tftp: and specify the location of the
image file in the format //host-ip/filepath or press
Enter to launch a prompt sequence.
flash: file-url Enter the keyword flash: and specify the location of the
image file in the format
//directory-path or press Enter
to launch a prompt sequence.
usbflash: file-
url
Enter the keyword usbflash: and specify the location of
the source file in the format
//directory-path to upgrade
form an external flash device or press Enter to launch a
prompt sequence.
A: | B: Specify the flash partition of the operating-system image to
be upgraded.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
9.0(0.0)
Added support for IPv6 for the file-url parameter.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for TFTP and SCP.
Version 7.6.1.0 Introduced on the S-Series.
File Management
73