Reference Guide

Usage
Information
Use the show diag information command to view the progress of offline
diagnostics on Z9500 CPUs: line-card processors (Linecard slots 0 to 2), Control
Processor (Linecard slot 3), and Route Processor (Linecard slot 4).
Example:
Before offline
diagnostics are
run on a switch
Dell# show diag information
Diag information:
Diag software image version:
9-2(1-509)
---------------------------------------------------------------
----
Linecard slot 0: No card diags executed yet (Card
Offline).
Linecard slot 1: No card diags executed yet (Card
Offline).
Linecard slot 2: No card diags executed yet (Card
Offline).
Linecard slot 3: No card diags executed yet (Card
Offline).
---------------------------------------------------------------
----
Example: After
offline
diagnostics are
run on a switch
Dell# show diag information
Diag information:
Diag software image version:
9-2(1-509)
---------------------------------------------------------------
----
Linecard slot 0: Card diags are done (Card Offline).
Linecard slot 1: Card diags are done (Card Offline).
Linecard slot 2: Card diags are done (Card Offline).
Linecard slot 3: Card diags are done (Card Offline).
---------------------------------------------------------------
----
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the verbose option.
Version 7.7.1.0 Introduced on the S-Series.
538
Debugging and Diagnostics