Reference Guide

UDP (RIP) any 520 _ Q15
RP 200
TCP (SSH) any 22 _ Q4
CP 400
TCP (TELNET) any 23 _ Q4
CP 400
VRRP any any _ Q15
RP 400
show ipv6 protocol-queue-mapping
Display the Z9500 CPU queue mapping for IPv6 protocols.
Z9500
Syntax
show ipv6 protocol-queue-mapping
Defaults Not configured.
Command
Modes
EXEC Privilege
Usage
Information
The show output displays information CPU traffic flows for supported IPv6
protocols, including the ingress queue at which the traffic is queued and the CPU
to which protocol traffic is sent with the applied rate limits (configured or default)
in kilobits per second (kbps). The egress port queues on CPUs are abbreviated as:
RP (Route Processor), CP (Control Processor), and LC (line card).
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Example
Dell#show ipv6 protocol-queue-mapping
Protocol Src-Port Dst-Port TcpFlag Queue EgPort
Rate (kbps)
-------- -------- -------- ------- ----- ------
-----------
TCP (BGP) any/179 179/any _ Q15
RP 2500
ICMP NA any any _ Q3/Q11 CP/
RP 600
ICMP RA any any _ Q3/Q11 CP/
RP 600
ICMP NS any any _ Q2/Q10 CP/
524
Control Plane Policing (CoPP)