Reference Guide

match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(1.0) Introduced on the Z9500.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
When you enter the redistribute ospf process-id command without any
other parameters, the software redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
Z9500
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to
65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(1.0) Introduced on the Z9500.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
488
Border Gateway Protocol