Reference Guide

Prompt Interface Type

Dell(conf-if-

fo-0/0)#

Forty-Gigabit Ethernet interface then slot/port information

Dell(conf-if-

lo-0)#

Loopback interface number

Dell(conf-if-

nu-0)#

Null Interface then zero

Dell(conf-if-

po-0)#

Port-channel interface number

Dell(conf-if-

vl-0)#

VLAN Interface then VLAN number (range 1–4094)

Dell(conf-if-

ma-0/0)#

Management Ethernet interface then slot/port information

Dell(conf-if-

tu-0)#

Tunnel interface then tunnel ID.

Dell(conf-if-

range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use

the ip access-list standard or ip access-list extended command.

To enter IP ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the ip access-list standard or ip access-list extended command. Include a name

for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

LLDP Mode

To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information,

refer to Link Layer Discovery Protocol (LLDP).

To enter LLDP mode:

1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP

on an interface, verify that you are logged in to INTERFACE mode.

2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-

interface-lldp).

LLDP MANAGEMENT INTERFACE Mode

To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP

MANAGEMENT INTERFACE mode. For more information, refer to Enabling LLDP on Management Ports in

the Dell Networking Z9500 Configuration Guide.

To enter LLDP MANAGEMENT INTERFACE mode:

CLI Basics