Reference Guide

Also, if you configure different passwords on the two routers, the following
message appears on the console:
%RPM0-P:RP1 %KERN-6-INT: BGP MD5 password mismatch from
[peer's IP address] : 11502 to [local router's IP address] :179
neighbor peer-group (assigning peers)
Allows you to assign one peer to an existing peer group.
Z9500
Syntax
neighbor ip-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ip-address peer-
group
peer-group-name command.
Parameters
ip-address Enter the IP address of the router to be included in the peer
group.
peer-group-
name
Enter the name of a configured peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
You can assign up to 256 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured
parameters. A peer cannot become part of a peer group if any of the following
commands are configured on the peer:
• neighbor advertisement-interval
• neighbor distribute-list
Border Gateway Protocol
363