Reference Guide

Version 7.7.1.0 Introduced on the C-Series.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
Z9500
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-
group-name} allowas-in command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
number Enter a number of times to allow this neighbor ID to use the
AS path. The range is from 1 to 10.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
Border Gateway Protocol
351