Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced.
Usage
Information
When you enable soft-reconfiguration for a neighbor and you execute the clear
ip bgp soft in
command, the update database stored in the router is replayed
and updates are re-evaluated. With this command, the replay and update process is
triggered only if route-refresh request is not negotiated with the peer. If the
request is indeed negotiated (after executing the clear ip bgp soft in
command), BGP sends a route-refresh request to the neighbor and receives all of
the peer’s updates.
Related
Commands
clear ip bgp — activates inbound policies without resetting the BGP TCP session.
capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Z9500
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Border Gateway Protocol
331