Reference Guide

To return to the default, use the no dot1x max-eap-req command.
Parameters
number Enter the number of times an EAP request is transmitted
before a session time-out. The range is from 1 to 10. The
default is 2.
Defaults 2
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
dot1x max-supplicants
Restrict the number of supplicants that can be authenticated and permitted to access the network
through the port. This configuration is only takes effect in Multi-Auth mode.
Z9500
Syntax
dot1x max-supplicants number
Parameters
number Enter the number of supplicants that can be authenticated
on a single port in Multi-Auth mode. The range is from 1 to
128. The default is 128.
Defaults 128 hosts can be authenticated on a single authenticator port.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
178
802.1X