Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class — restricts the incoming connections to a particular IP address in an
IP access control list (ACL).
password — specifies a password for users on terminal lines.
logging coredump server
Configure the switch to move (upload) a core dump for an application or kernel crash to an external FTP
server.
Z9500
Syntax
logging coredump server {ipv4-address | ipv6-address} username
name password [type] password
Parameters
{ipv4-address |
ipv6-address}
Enter the server IPv4 address (A.B.C.D) or IPv6 address
(X:X:X:X::X).
name Enter a username to access the target server.
type Enter the password type:
• Enter 0 to enter an unencrypted password.
• Enter 7 to enter a password that has already been
encrypted using a Type 7 hashing algorithm.
password Enter a password to access the target server.
Defaults Core dumps for kernal and application crashes are stored in the local flash of the
Z9500 Control Processor CPU.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring
103