Users Guide
Switch Management 93
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_SwitchManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
2. Find the line in the setup file relevant to the device
—
When the correct
setup file is found, it is searched for a line relevant to the device, as
follows:
– The setup file is searched for a line with format A or B in which there
is a match to the device's MAC address. If such line is found, and its
format is valid (the <flag> field is empty), the line is applied.
– If no line for the specific device was found, the setup file is searched
for valid lines with formats C or D. The first line found is applied.
3. Apply the correct line.
When the correct line in the setup file is found, it
is applied, as follows:
– If the line contains an IP address and IP mask, the IP address is
configured on the default VLAN.
– If the line contains an image file and its version differs from the
current image file version, the USB image file is loaded and the switch
is rebooted.
– If a new image file was loaded, it is loaded onto all units in the stack.
– If the line contains a configuration file, the configuration file is
appended to running configuration file.
4. Mark the flag in the applied line
.
When the line is applied (successfully
or not), its flag is set, as follows:
– If the line contains an IP address and IP mask (format C or D), the IP
address is configured on the default VLAN and the line is marked as
"in-use". This ensures that the line is not used for another device.
– If the line was not applied successfully, for one of the following
reasons, the line is marked as "invalid" and a SYSLOG message is sent.
• The configuration file specified by the line does not exist on the
USB key or is corrupted.
• The image file specified by the line does not exist on the USB key
or is corrupted.
– If parsing of the line failed for some other reason, the line is ignored
and a SYSLOG message is sent.
NOTE: When both Auto-Update and Auto-Configuration are performed, the image
file is loaded first, the device is booted and then the configuration file is loaded.