Users Guide

122 Switch Management
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_SwitchManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
To add a RADIUS server:
1
Click Switch Management > Management Security > RADIUS .
The RADIUS default parameters and previously-defined RADIUS servers
are displayed.
2 To set the global parameters, click Edit, Settings Icon ( ) and enter the
following fields:
–
Source IPv4 Interface — Enter the address of the IPv4 interface used
to connect to the RADIUS server.
–
Source IPv6 Interface — Enter the address of the IPv6 interface used
to connect to the RADIUS server.
–
Key String — Enter the key of the TACACS+ server.
–
Timeout for Replay (sec) — Enter the amount of time that can pass
before the connection between the device and the TACACS+ server
times out.
–
Number of Retries — Enter the number of requests sent to the
RADIUS server before a failure occurs.
–
Dead Time (sec) — The amount of time (in minutes) that a RADIUS
server is bypassed for service requests.
3 Click OK .
4 To add a RADIUS server, click Edit, Add , and enter the fields:
–
Supported IP Format — Select whether the IPv4 or IPv6 format is
supported.
–
IPv6 Address Type — Select whether the Link-Local or Global format
of the
IPv6 Address is supported.
–
Host IP Address — Enter the RADIUS server IP address.
–
Priority — Enter the priority of the RADIUS server being added. 0 is
the highest value. This is used to configure the order in which servers
are queried.
–
Authentication Port — Enter the authentication port used to verify
the RADIUS server authentication. Enter 0 if you do not want this
server to be used for authentication purposes.