Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Power on VEP4600
Plug in a power cord to the back of VEP4600 platform. The platform starts to power up immediately.
Create a serial console connection
To establish a console connection use a universal serial bus (USB)-to-RS-232 connection from a USB port to a VEP4600
console port.
NOTE: Use a 115200 baud rate.
puTTY 115200 baud rate setup
BIOS access process
1. Press the delete button after the POST Lower DRAM Memory test appears on the screen.
Continue pressing the delete button to progress to the BIOS setup and configuration screen.
NOTE:
If the BIOS setup and configuration screen window passes, power off and power on the platform again
to restart the boot up process.
Current released firmware 71