Setup Guide

CAUTION: Professional installation instructions: Products with WIFI and Bluetooth capabilities need to be installed by
qualified personnel with RF and regulatory related knowledge. The general user shall not attempt to install or change
any wireless settings.
Ground cable
To attach a ground cable to the switch, use the included two M3 ground lug bracket screws. The switch ships with the M3 ground lug
bracket screws attached.
NOTE: For AC-powered platforms, although the third conductor of the AC power cord provides a ground path, Dell EMC
recommends grounding your platform with a dedicated ground wire.
The ground cable is not included. To properly ground the platform, Dell EMC recommends a one- or two-hole lug, M3 hole size. The
ground lug must be a UL-recognized, crimp-type lug.
CAUTION:
Grounding conductors must be made of copper. Do not use aluminum conductors.
NOTE: Coat the one-hole lug with an anti-oxidant compound before crimping. Also, bring any unplated mating surfaces
to a shiny finish and coat with an anti-oxidant before mating. Plated mating surfaces must be clean and free from
contamination.
NOTE: The rack installation ears are not suitable for grounding.
Before you install the switch into the dual-tray:
1. Cut the ground cable (not included) to the desired length. The cable length must facilitate proper operation of the fault interrupt
circuits. Use the shortest cable route allowable.
2. Unscrew the two attached M3 screws and set aside.
3. Attach the ground lug and bracket to the switch using the M3 screws.
Figure 2. VEP4600 ground lug attached
4. Attach the other end of the ground cable to a suitable ground point such as the rack or cabinet.
Rack or cabinet installation
You may either place the platform on a rack shelf or mount the platform directly into a 19" wide, EIA-310- E-compliant rack.
The platform includes two-post rail assemblies.
WARNING:
This guide is a condensed reference. Read the safety instructions in your Safety, Environmental, and
Regulatory information booklet before you begin.
NOTE: The illustrations in this section are not intended to represent a specific platform.
8 VEP4600 installation