Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
RomImage Image 1 Image 2
ModuleName Description Version Version Version
1. boot BootLoader 0.2.000000 0.2.000000 0.2.000000
2. conf ConfigParams 0.20.000000 0.20.000000 0.20.000000
3. root Root 0.20.000000 0.20.000000 0.20.000000
4. osimage Linux OS 0.20.000000 0.20.000000 0.20.000000
5. www Web Pages 0.20.000000 0.20.000000 0.20.000000
6. testapps 0.20.000000 0.20.000000 0.20.000000
7. ast2500e 1.0.000000 1.0.000000 0.20.0
Existing Image and Current Image are Same
So,Type (Y/y) to do Full Firmware Upgrade or (N/n) to exit
Enter your Option : y
****************************************************
WARNING!
FIRMWARE UPGRADE MUST NOT BE INTERRUPTED ONCE IT IS STARTED.
PLEASE DO NOT USE THIS FLASH TOOL FROM THE REDIRECTION CONSOLE.
****************************************************
Uploading Firmware Image : 100%... done
Skipping [boot] Module ....
Flashing [conf] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Flashing [root] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Flashing [osimage] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Flashing [www] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Flashing [testapps] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Flashing [ast2500e] Module ....
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Resetting the firmware..........
write BMC image success
Enable device protect
Update BMC image success
root@dellemc-diag-os:~#
NOTE:
Switch to BMC console to monitor the BMC update status. Confirm BMC updates. Reboot the system. Proceed to
BIOS update.
Update BIOS in DIAG OS
Manual or automatic BMC, BIOS, and CPLD firmware upgrades is required before VEP4600 Expansion Card installation.
Use the following DIAG OS command to update BIOS:
NOTE:
For updating BIOS use the following command:
updatetool -D BIOS -U -e VEP4600-BIOS-x.xx.x.x-xx.BIN
Update CPLD in DIAG OS
About this task
Steps
1. Use the following DIAG OS command to update CPLD:
76
Current released firmware