Users Guide

Table 4. Firewall set parameters
Type specific param # Parameter data
Remove the IPv6 address rule 31
Data 1:16—IPv6 address
MS-byte first. This is an IPv6 address
that is blocked or unblocked based on
state.
Remove the IPv6 address range rule 32
Data 1:16—IPv6 address range
1:16]—Starting IP address from which
IPs are blocked or unblocked based on
the state.
[17.32]—Ending IP address until IPs are
blocked or unblocked based on the state.
Add the IPv6 port number rule 33
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
Add the IPv6 port number range rule 34
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
[4:5]—Port number till the ports are
blocked or u nblocked based on the
state.
Remove the IPv6 port number rule 35
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
Remove the IPv6 port number range rule 36
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
[4:5]—Port number till the ports are
blocked or u nblocked based on the
state.
Event log
To get the IPMI event log, use the ipmitool sel list command.
To clear the event log, use the ipmitool sel clear command.
66
Configuration methods