Users Guide

Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
[4:9]—Year
Date 4:9—Start time
[4:5]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
6—month
7—date
8—hour
9—minute
Date 10-15—stop time
[10:11]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
12—month
12—date
14—hour
15—minute
Remove the IPv6 port range with
timeout rule
28
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
[4:5]—Year
Date 6:11—Start time
[6:7]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
8—month
9—date
10—hour
11—minute
Date 12-17—stop time
[12:13]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
14—month
15—date
16—hour
17—minute
Add the IPv6 address rule 29
Data 1:16—IPv6 address
MS-byte first. This is an IPv6 address
that is blocked or unblocked based on
state.
Add the IPv6 address range rule 30
Data 1:16—IPv6 address range
[1:16]—Starting IP address from which
IPs are blocked or unblocked based on
the state.
[17.32]—Ending IP address until IPs are
blocked or unblocked based on the state.
Configuration methods 65