Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
Bit 0—IPv4
Date 2:7—Start time
[2:3]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
4—month
5—date
6—hour
7—minute
Date 8:13—Stop time
[8:9]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
10—month
11—date
12—hour
13—minute
Remove drop all Ipv4 or IPv6 with
timeout rule
20
Add iptables rules to block IPv4 and IPv6
traffic to the BMC. The state selector is
not used.
Data1: Protocol
Bit 7:2—Reserved
Bit 1—IPv6
Bit 0—IPv4
Date 2:7—Start time
[2:3]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
4—month
5—date
6—hour
7—minute
Date 8:13—Stop time
[8:9]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
10—month
11—date
12—hour
13—minute
Add IPv6 address with timeout rule 21
Data 1:16—IPv6 address
MS-byte first. The IPv6 address type
blocked or unblocked based on the state.
Date 7:22—Start time
[17:18]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
19—month
20—date
21—hour
22—minute
Date 23-28—stop time
[23:24]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
25—month
62 Configuration methods