Command Line Reference Guide

Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added the list option and removed the prefix-list
option.
Version 7.4.1.0 Introduced
Usage
Information
If a list is not specified, all SA messages received from the default peer are
accepted. You can enter multiple default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
S6000
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
930
Multicast Source Discovery Protocol (MSDP)