Command Line Reference Guide

ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
S6000
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{
number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Related
Commands
show ip msdp sa-cache rejected-sa
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S6000
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address} list name command.
Multicast Source Discovery Protocol (MSDP)
929