Command Line Reference Guide

If you disable FEFD globally (no fefd-global), the system does not remove the
FEFD interface configuration.
Related
Commands
• fefd — enables far-end failure detection.
• fefd-global interval — configures an interval between FEFD control packets.
• show fefd — shows the FEFD command output.
show fefd
View FEFD status globally or on a specific interface.
S6000
Syntax
show fefd [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Legacy E-
Series
command.
Usage
Information
The following describes the show fefd command shown in the following
example.
Layer 2
897