Command Line Reference Guide

debug fefd
Enable debugging of FEFD.
S6000
Syntax
debug fefd {events | packets} [interface]
To disable debugging of FEFD, use the no debug fefd {events | packets}
[interface] command.
Parameters
events Enter the keyword events to enable debugging of FEFD
state changes.
packets Enter the keyword packets to enable debugging of FEFD to
view information on packets sent and received.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Legacy E-
Series
command.
Related
Commands
• fefd — enables far-end failure detection on an interface.
• fefd reset — enables FEFD globally on the system.
890
Layer 2