Command Line Reference Guide

mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
S6000
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the
Layer 2 chapter in the Dell Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
S6000
Syntax
mac learning-limit address_limit [vlan vlan-id] [station-move-
violation [dynamic]] [dynamic [no-station-move| station-move]]
Parameters
address_limit Enter the maximum number of MAC addresses that can be
learned on the interface. The range is from 1 to 1000000.
vlan vlan-id Enter the keyword then the VLAN ID. The range is from 1 to
4094.
dynamic (OPTIONAL) Enter the keyword dynamic to allow aging of
MACs even though a learning limit is configured.
868
Layer 2