Command Line Reference Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
S6000
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout
command.
Defaults 1 second
Command
Modes
INTERFACE (conf-if-po-number)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
860
Link Aggregation Control Protocol (LACP)