Command Line Reference Guide

To return to the default values, use the no distribute-list prefix-list-
name out [bgp as number connected | ospf process-id | rip |
static] command.
Parameters
prefix-list-
name
Specify the prefix list to filter prefixes in routing updates.
connected (OPTIONAL) Enter the keyword connected for directly
connected routing process.
ospf process-id (OPTIONAL) Enter the keyword ospf then the OSPF
process-ID number. The range is from 1 to 65535.
bgp as number (OPTIONAL) Enter the BGP then the AS Number. The range is
from 1 to 65535.
rip (OPTIONAL) Enter the keyword rip for RIP routes.
static (OPTIONAL) Enter the keyword static for user-configured
routing process.
Defaults Not configured.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.5.1.0 Added IPv6 ISIS support.
Version 6.3.1.0 Introduced.
Usage
Information
You can assign a name to a routing process so a prefix list IS applied to only the
routes derived from the specified routing process.
Related
Commands
• distribute-list in — filters the networks received in updates.
• redistribute — redistributes routes from one routing domain to another routing
domain.
Intermediate System to Intermediate System (IS-IS)
805