Command Line Reference Guide

cam-acl-egress
Allocate space for IPv6 egress ACLs.
S6000
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as
follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4
ipv4acl 1- 4
ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-
config (write-mem or copy run start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell#
Dell#configure
Dell(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)#cam-acl-egress l2acl ?
IPv6 Access Control Lists (IPv6 ACLs)
787