Command Line Reference Guide

connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.1.0 Introduced on the C- and E-Series.
Version 8.3.7.0 Introduced on the S4810.
Example
Dell#show ipv6 management-route
IPv6 Destination Gateway State
---------------- ------- -----
2001:34::0/64 ManagementEthernet 0/0 Connected
2001:68::0/64 2001:34::16 Active
Dell#
show ip protocols
View information on all routing protocols enabled and active on the switch.
S6000
Syntax
show ip protocols
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
762
IPv4 Routing