Command Line Reference Guide

Usage
Information
The following describes the show ip interface brief command shown in the
following example.
Fields Description
Interface Displays type of interface and the associated slot and port
number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the configuration is read from the saved
configuration.
Status States whether the interface is enabled (up) or disabled
(administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method
Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively
down down
GigabitEthernet 1/1 unassigned NO Manual administratively
down down
GigabitEthernet 1/2 unassigned YES Manual
up up
GigabitEthernet 1/3 unassigned YES Manual
up up
GigabitEthernet 1/4 unassigned YES Manual
up up
GigabitEthernet 1/5 10.10.10.1 YES Manual
up up
GigabitEthernet 1/6 unassigned NO Manual administratively
down down
show ip management-route
View the IP addresses assigned to the Management interface.
S6000
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
760
IPv4 Routing