Command Line Reference Guide

show ip interface
View IP-related information on all interfaces.
S6000
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and slot/port or number
information, the valid range of slot number is from 0 to 5:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet then zero (0).
• For the Null interface, enter the keyword null then zero
(0).
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a stack-unit interface, enter the keyword stack-
unit
then the stack unit number. The range is from 0 to
7.
• For a tunnel interface, enter the keyword tunnel then
the tunnel interface number. The range is from 1 to
16383.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief
summary of the interfaces and whether an IP address is
assigned.
configured (OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
758
IPv4 Routing