Command Line Reference Guide

summary (OPTIONAL) Enter the keyword summary to view the total
number of prefixes in the FIB.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-
Addr Port VId EC
---------------------------------------------------------------
----------------------------
1.1.1.2/32 via 1.1.1.2, Vl 1000 1.1.1.2
00:01:00:00:00:02 Te 7/42 1000 0
2.1.1.2/32 via 2.1.1.2, Vl 20 2.1.1.2
00:03:00:00:00:02 Po 10 20 0
IPv4 Routing
755