Command Line Reference Guide

pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
S6000
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address
[mask] | macaddress mac-address [mac-address mask]] [retries]
[static | dynamic] [inspection {database | statistics][summary]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF.
NOTE: Use this attribute to start a BGP instance for either
a specific address family corresponding to the default
VRF or an IPv4 address family corresponding to a non-
default VRF.
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For the Management interface, enter the keyword
managementethernet then the slot/port information.
• For a Port Channel interface, enter the keyword port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
746
IPv4 Routing