Command Line Reference Guide

00:60:CF:20:7B:8C to 113.3.3.254
Dell#
Related
Commands
ip helper-address – specifies the destination broadcast or host address for the
DHCP server request.
ip helper-address hop-count disable – disables the hop-count increment for the
DHCP relay agent.
debug ip icmp
View information on the internal control message protocol (ICMP).
S6000
Syntax
debug ip icmp [interface] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a Tunnel interface, enter the keywords tunnel then a
number. The range is from 1 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value.
The range is from 1 to 65534. The default is Infinity.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
718
IPv4 Routing