Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version
8.3.19.0
Introduced on the S4820T.
Usage
Information
To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib stack-unit — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
S6000
Syntax
clear ip route [vrf vrf-name] {* | ip-address mask}
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to clear the routes corresponding to that VRF.
* Enter an asterisk (*) to clear all learned IP routes.
ip-address
mask
Enter a specific IP address and mask in dotted decimal
format to clear that IP address from the routing table.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
IPv4 Routing
713