Command Line Reference Guide

clear host
Remove one or all dynamically learned host table entries.
S6000
Syntax
clear host name
Parameters
name Enter the name of the host to delete. Enter * to delete all
host table entries.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
clear ip fib stack-unit
Clear all FIB entries in the specified stack unit (use this command with caution, refer to Usage
Information.)
S6000
Syntax
clear ip fib stack-unit unit-number vrf vrf-name
Parameters
unit-number Enter the number of the stack unit. The range is from 0 to 11.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
clear all FIB entries corresponding to that VRF.
Command
Modes
EXEC Privilege
712
IPv4 Routing