Command Line Reference Guide

1. At time t=0, Dell Networking OS sends an ARP request for IP A.B.C.D.
2. At time t=1, Dell Networking OS receives an ARP request for IP A.B.C.D.
3. At time t=2, Dell Networking OS installs an ARP entry for A.B.C.D only on RP2.
Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is
received, Dell Networking OS installs an ARP entry on all three CPUs.
arp max-entries
Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the name of a specific VRF for which you want to
configure maximum number of ARP entries that IPv4 allows.
max-number Enter the maximum number of ARP entries that a VRF RTM
can hold. The range is from 0 to 65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S4810 and S4820T.
Usage
Information
Use this command to specify the maximum number of ARP entries that the Route
Table Manager can hold for a specific VRF. This command does not apply to the
management VRFs.
708
IPv4 Routing