Command Line Reference Guide

show interfaces port-channel — displays information on configured Port Channel
groups.
show interfaces port-channel
Display information on configured Port Channel groups.
S6000
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-
number
For a Port Channel interface, enter the keyword port-
channel then a number. For the C-Series and S-Series, the
range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the
port channel number, the state of the port channel, and the
number of interfaces in the port channel.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series. Modified to display the LAG
failover group status.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following describes the show interfaces port-channel command shown
in the following example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the
LAG’s LAG fate-sharing group (“Failover-group”) is listed.
698
Interfaces