Command Line Reference Guide

Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface null — configures a null interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the
LAG to be also in “oper up” status.
S6000
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 16. The default is 1.
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 8. The default is 1.
Defaults 1
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
696
Interfaces