Command Line Reference Guide

port-channel
number
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults none
Command
Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP
mode to configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel
groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical
interfaces on the S-Series.
S6000
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-
number
command.
Parameters
channel-
number
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command
Modes
CONFIGURATION
694
Interfaces