Command Line Reference Guide

no shutdown
Dell(conf-if-fo-0/4)#
show config (for speed)
S6000
Syntax
show config
Command
Modes
Dell(conf-if-te-2/10)#show config
Command
History
Version 9.3(0.1) Introduced on the S6000.
Example
Dell(conf-if-te-0/0)#speed ?
10 10 Mbps
100 100 Mbps
1000 1000 Mbps
Dell(conf-if-te-0/0)#speed 100
Dell(conf-if-te-2/10)#show config
interface TenGigabitEthernet 2/10
speed 100
no shutdown
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
S6000
Syntax
show config
Command
Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
Interfaces
665