Command Line Reference Guide

• MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot
be enabled simultaneously.
Example (Single
Range)
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a loopback interface.
interface null — configures a null interface.
interface port-channel — configures a port channel group.
show vlan — displays the current VLAN configuration on the switch.
shutdown — disables/enables the VLAN.
tagged — adds a Layer 2 interface to a VLAN as a tagged interface.
untagged — adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
S6000
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces
653