Command Line Reference Guide

lacp fast-switchover
Cause the physical ports to be aggregated faster by configuring this capability in a port-channel on both
the nodes that are members of a port-channel.
S6000
Syntax
lacp fast-switchover
To disable the capability of faster aggregation of the member ports of a LAG or a
port-channel bundle, use the no version of this command.
Defaults Not configured
Command
Modes
INTERFACE (conf-if-po-number)
Command
History
Version 9.3(0.0) Introduced on the S6000.
Usage
Information
You can configure the optimal switchover functionality for LACP even if you do not
enable the fast boot mode on the system. You must configure the long timeout
mechanism for the LACP session to enable the fast boot capability to operate
properly. This command applies to dynamic port-channel interfaces only. When
applied on a static port-channel, this command has no effect.
If you configure the optimized booting-time capability and perform a reload of the
system, the LACP application sends PDUs across all the active LACP links
immediately.
Related
Commands
show lacp — displays the LACP configuration.
encapsulation dot1q
Configures lite-subinterfaces. This command is supported on the S6000 platform.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no version of this
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which
the host belongs. The range is from 1 to 4094. A lite
subinterface is considered as a Layer 3 port property and is
synchronous with the existing rules of applying Layer 2 or
Layer 3 properties to an interface.
Command
Modes
INTERFACE
564
Flex Hash and Optimized Boot-Up