Command Line Reference Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an
automatic process. A warning message appears when the offline stack-unit
command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Related
Commands
show environment (S-Series) — views the S-Series system component status (for
example, temperature, voltage).
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
S6000
Syntax
clear hardware stack-unit id {counters | unit 0–0 counters |
cpu data-plane statistics | cpu i2c statistics | cpu party-bus
statistics | cpu sata-interface statistics | stack-port 0–127}
Parameters
stack-unit id Enter the keywords stack-unit then a number to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data. The
range is 0 to 5.
counters Enter the keyword counters to clear the counters on the
selected stack member.
Debugging and Diagnostics
509