Command Line Reference Guide

and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.
priority-pgid
Assign 802.1p priority traffic to a priority group in a DCB map.
S6000
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-
num dot1p3_group-num dot1p4_group-num dot1p5_group-num
dot1p6_group-num dot1p7_group-num
Parameters
dot1p0_group-
num
Enter the priority group number for each 802.1p class of
traffic in a DCB map.
dot1p1_group-
num
dot1p2_group-
num
dot1p3_group-
num
dot1p4_group-
num
dot1p5_group-
num
dot1p6_group-
num
dot1p7_group-
num
Defaults None
Command
Modes
DCB MAP
Command
History
Version 9.3(0.0) Introduced on the S4810, S6000 platforms.
482
Data Center Bridging (DCB)